FAQ
-
No sound when using the kit
When the kit is used, there is no sound. First check if the indicator status of the kit transmitter and receiver is normal. Then remove the kit wireless transceiver and replace it with a wired connection. If there is sound on the wired connection, it is determined that the wireless transceiver is faulty. Turn off the Kit transceiver and turn it on again to see if it can be properly turned on and paired. If it can automatically pair and connect, then re-wire the wired connection to Kit wireless connection. If there is still no sound, you can be sure that the Kit transceiver is faulty.
-
Kit with broken sound when used
When the Kit is used, there is broken sound. It can also be eliminated step by step. The broken sound is usually an overload of the signal, and there may be an overload in the input and output. The Kit transmitter input range is between 0~1V, and the receiver output range is between 0~4.2V. If the input signal connected to your transmitter is higher than 1V or the device input connected to the receiver is less than 4.2V, the overload will occur. And broken sound, you only need to turn down the volume of the sound source device, and the overload will also weaken or disappear.
-
Kit charging light will only light up after a while
Sometimes when the kit transceiver is charging, the indicator light will be on for a while. This is because the internal lithium battery circuit of the kit has been overprotected, causing the main control chip to enter the undervoltage reset state and cannot indicate the battery level. When the battery passes a short period of time After the time is charged, the main control chip can return to the normal working state to indicate the battery power. This is a normal phenomenon, and the user does not have to worry.
-
No sound when connecting speakers with Forara pickups
Forara pickups need to be used with low-impedance input amplifiers. When using Forara pickups to connect directly to the audio, the plug must be plugged into the guitar interface. If there is no sound after insertion, check if the audio has power. If the setting is correct, turn the volume knob to see if it is normal. After the volume is turned on, there is still no sound. Disconnect the guitar tail pin and the connecting cable. Touch the end of the guitar cable plug with your hand to listen to the speaker. If you have a cable, touch the plug and see if there is any sound. This method can gradually determine which device in the guitar pickup, guitar cable, and guitar sound has a problem.
-
Forara pickups are noisy and have poor sound quality.
Electromagnetic pickups are the best internal recording and pickup solution for steel strings. The electromagnetic pickup can pick up more details than other pickups. If the connecting line is a common connecting line, such a line will produce a large parasitic Capacitor, this parameter will make the frequency response of the sound become uneven, and then amplified and amplified, this effect will become more and more obvious, not only will there be distortion, and noise will often accompany it. Therefore, you must use a high-fidelity professional audio cable before the sound reinforcement. It is recommended to use a two-core unbalanced professional audio cable such as canner and mogami, and the length of the one-time connection should not exceed 3 meters. The parasitic capacitance parameters are small and the fidelity is better.
-
No sound when using Bar pickups
Bar pickups are powered by batteries. The idea of fault diagnosis is that the pickups, cables, and audio are eliminated one by one. You can use the Forara pickup to find the problem without sound. And because the Bar pickup is a battery-powered pickup, if it is convenient, it is recommended. First replace the new 9V battery, and at the same time, modulate the pickup volume knob to the maximum, and then find the problem in the next step. For the method of finding the problem, please refer to the Forara pickup no sound search method.
-
The sound quality of the Bar pickup begins to deteriorate
The Bar pickup has a better pickup effect and a larger output signal. It is recommended to use a two-core unbalanced audio cable such as canner or mogami.